media find_edge edge Thermal Enables (1) or disables (0) edge detection for this mode. If set to 0, imaging will start at the approximate plate edge. Disabling edge detection will make the registration between multiple plates poor. Works with mode edge parameter. If mode edge is set to 0, edge detection is disabled. As of NVS module V2.16 (July, 2001), setting this parameter to 2 means that the firmware will accept a "double edge" (i.e., head 'sees' two edges while scanning the plate) integer
  • 1
    •
  • 0 to 2
    •      cal
  • ../nvs/mode_cal_edge.xmlNVS: mode edge
    •
  • ..\..\ShowAllErrors.htmFirmware 0 Error Index
  • ..\..\ShowAllCommands.htmFirmware 0 Command Index
  • ..\..\ShowAllNVS.htmFirmware 0 NVS Index
    •  Updated: Wed Jul 16 19:37:12 2008 PST